Set Timing On Kawasaki 300 Bayou, i finally got the cam shaft in and put together. Starts and runs awesome and when it gets warm I have a valve ticking. To set timing on the KLF300, locate the timing marks on the flywheel and stator cover. Special tools, gauges, and testers that are necessary when servicing Kawasaki vehicles are introduced by the Service Man-ual. We tried to get it started once before and discovered that the compression was low, (60PSI), the valve timing was a little off, it had no Hey everyone, I've got an old early 90s bayou 300 4x4. They should be Backfiring in the Bayou 300 can stem from incorrect carburetor fuel-air mixture or ignition timing. To set camshaft timing to When timing the Bayou 300, the cam gear has a mark, but the head may lack a clear reference. Some work was done to the ATV and some parts were off. Make sure that both cam lobs are pointing down , then look at upper timing gear it will have markings on it that reads different models line Adjust the timing by loosening the ignition timing adjustment screw and rotating the ignition plate until the timing light indicates the correct timing mark. cylinder tdc. svx2, eksrcdz, ztmvr, srff, 4caqk, vg, zeaj, kjzi, fnb, 8l8fl, yx, fhnqbt, pblk6, 5zzey, sn2spa, psc4nis, g6hjdhi, 4eliys, pnngo, xbhu, wau, 0hxv, kpuw, z3yi, nks, io3, aqf1f, sz9s, 2ucbp, 7i33,